top of page

Ergonomics Regulations, 2019: what every South African employer must do

Christo de Wet
Oct 23
5 min read

The Ergonomics Regulations, 2019 require every South African employer whose work may expose employees to ergonomic risks to have a competent person assess those risks before the work starts, repeat the assessment at least every two years, control the risks in hierarchy order, train employees, and keep the assessment and medical surveillance records for 40 years. They apply to all workplaces under the Occupational Health and Safety Act, from factories and warehouses to offices and vehicles. No approved inspection authority is needed.


The regulations were published under section 43 of the Occupational Health and Safety Act 85 of 1993 as Government Notice R. 1589 of 6 December 2019, and took effect on publication. They were the first South African regulations to make ergonomics a stand-alone legal duty rather than a general one under section 8 of the Act.


Who the Ergonomics Regulations apply to

Regulation 2 applies them to every employer and self-employed person who carries out work at a workplace that may expose any person to an ergonomic risk, and to designers, manufacturers, importers and suppliers of workplace equipment and systems of work. Ergonomic risk is defined broadly: any characteristic of work that may harm health, from lifting and awkward postures to repetitive movement, vibration, workstation design, work pace and shift patterns.


What employers must do, regulation by regulation

  • Information and training (regulation 3): tell employees about the ergonomic risks in their work, the results of the risk assessment and medical surveillance, the controls in place and how to use them, before they start and whenever the risks change.

  • Ergonomic risk assessment (regulation 6): a competent person must assess the risks before work that may expose employees starts, then at intervals not exceeding two years. The employer must consult the health and safety committee or representatives first. The assessment identifies the hazards, who may be affected and how, then analyses, evaluates and prioritises the risks.

  • Risk control (regulation 7): where the assessment shows a risk, control it in hierarchy order: eliminate it, substitute the task or equipment, redesign the work, then administrative controls such as job rotation, with personal protective equipment last. Controls must be implemented within a reasonable time and reviewed.

  • Medical surveillance (regulation 8): where the assessment indicates that employees are exposed to ergonomic risks that may cause harm, the employer must put them under medical surveillance overseen by an occupational medicine practitioner. The programme is based on the risk assessment and the practitioner's recommendations.

  • Maintenance of controls (regulation 9): keep engineering and other controls in working order and check them at the intervals the competent person recommends.

  • Records (regulation 10): keep the risk assessment and the medical surveillance records for at least 40 years, the risk control and maintenance records for at least three years, and each employee's training records for as long as that employee is at the workplace.


When the assessment must be reviewed early

Regulation 6(3) requires a review before the two years are up if the controls stop working, the work methods, type of work or control equipment change, or an incident or medical surveillance finding is linked to an ergonomic risk. A new production line, a new product, a change in shift length or a spate of back or shoulder complaints are all triggers.


Who counts as a competent person

The regulations define a competent person as someone with the knowledge, training and experience in ergonomics specific to the work being performed, who knows the Act and the regulations. No registration is prescribed, so the employer must satisfy itself that the assessor can defend the method used. An assessment that uses recognised tools such as REBA, RULA, the NIOSH lifting equation, the Key Indicator Method or the MAC chart, and that shows the reasoning behind each risk rating, is far easier to defend to an inspector than a checklist.


What inspectors look for

  • A written ergonomic risk assessment dated within the last two years, signed by a named competent person.

  • Proof that the health and safety committee was consulted before the assessment.

  • A control plan that follows the hierarchy, with dates and owners, and evidence that the controls were put in place.

  • Training records that mention ergonomic risks, not only general induction.

  • A medical surveillance programme where the assessment calls for one.


Five questions to ask about your ergonomics compliance

  • Do you have an ergonomic risk assessment less than two years old for every job type that involves lifting, repetitive work, awkward postures, vibration or long periods at a screen?

  • Was it done by someone who can explain the method and the ratings?

  • Has anything changed since it was done that regulation 6(3) would count as a trigger?

  • Are the controls it recommended in place, and is anyone checking them?

  • Could you hand the records to an inspector tomorrow?


How Qualitas can help

Our ergonomic risk assessments are done by a SAIOH-registered occupational hygienist using REBA, RULA, the NIOSH lifting equation, KIM and MAC, combined as the task needs, and the report ranks tasks by risk and sets out controls in hierarchy order. For what the assessment itself covers, see what does an ergonomic risk assessment cover? Ergonomics is outside our approved inspection authority scope, as the regulations require no AIA, but it follows the same SANAS-accredited quality system as our noise, chemical, lead and asbestos work.


Frequently asked questions

Do the Ergonomics Regulations apply to offices?

Yes. They apply to any workplace where work may expose a person to ergonomic risk, and screen work, seating and workstation layout are named examples of such risk. An office with computer users needs an ergonomic risk assessment like a factory does, although it is usually a shorter one.


Is there a maximum weight an employee may lift?

No. The regulations set no weight limit. The competent person must assess each lifting task on its load, frequency, distance, height and posture, using a method such as the NIOSH lifting equation or the MAC chart, and recommend controls where the risk is too high.


How often must an ergonomic risk assessment be repeated?

At intervals not exceeding two years under regulation 6(1), and sooner under regulation 6(3) if controls fail, the work or equipment changes, or an incident or medical surveillance finding is linked to an ergonomic risk.


Not sure what your site needs? Start with our free Compliance Gap Assessment, request a quote, or call or WhatsApp 082 649 6599.


This article is general guidance based on the Ergonomics Regulations, 2019 under the Occupational Health and Safety Act 85 of 1993, as published in December 2019. It is not legal advice. Check the current text of the regulations and any amendments before relying on it.


Christo de Wet is a SAIOH-registered occupational hygienist with 15 years' experience and the director of Qualitas Occupational Consulting.

Comments


Commenting on this post isn't available anymore. Contact the site owner for more info.
bottom of page